Display controller cable Smartgyro Crossover Dual Max

Description

The display cable for Smartgyro Crossover Dual Max controllers is an essential link for reconnecting the display to the control electronics. Replacing a damaged, pinched or cut harness, it re-establishes communication between the cockpit and the controller, enabling normal operation of the display and electrical system commands.

User benefits

This display cable helps you get your soft mobility device back into service by re-establishing the connection between controller and display. It helps avoid the false contacts and intermittent cuts typical of a tired cable, and facilitates a clean repair without modifying the original wiring when replacement is necessary.

Technical specifications (information available)

Product type: display cable (display/controller link).
Function: connection between display and controller of an electrical system.
Family: cable bus and accessories, electronics.

Recommended uses

Recommended for replacing a faulty display cable on Smartgyro Crossover Dual Max: display failure, loss of communication, malfunction linked to the harness between the control station and the controller, or repair after cable pull-out/crushing.

Known compatibilities

Compatible with the Smartgyro Crossover Dual Max controller (display cable for this model).

Expert advice

Before replacement, switch off the power supply and disconnect the battery, if accessible, to avoid short-circuiting the electronics. Check that the fault is in the harness (severed cable, damaged connector, oxidation, bent pins) and not in the display or controller. During assembly, make sure the cable runs smoothly (no pinching, no tension, wide bending radius) and secure it with suitable fasteners to limit vibration and extend the life of the cable bus.